What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 09:03

This one hit behind the barn.
This is where the MOV conducts again, and dissipated the energy.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Cloudy skies can’t dim joy as thousands fill nation’s capital for World Pride parade - AP News
In schematic diagrams this is the symbol for a fuse:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Are you already having anal sex?
A fuse is a non-resetable over current circuit protector.
(Dc diagram shown, AC is similar).
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Mariners set return date for ace Logan Gilbert - The Seattle Times
But… the neutral is now “floating” because of the 1 ohm resistance.
The third is lightning and “how it gets conducted into a home.”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
If you were president, how would you make America "great again?"
Upvotes:
But it can get overloaded, and no longer works.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Hollywood actress popular for hit ’70s shows dead at 95 - NJ.com
The bolt then partially travels down the line to your home.
It also is a device that limits the change in current flow.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Hayley Williams Reacts Angrily to Michael Tait Christian Music Scandal - Variety
[image of Common-mode choke]
2024–10–10[John johnson John Johnson ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
How humpback whales are playfully communicating with humans, according to scientists - ABC News
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
but I think this circuit , shows a few more pieces.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
What is lightning?
At least they know the answer if they wanted it.
NASA Discovers That Venus’ Surface Is Still Alive: New Evidence of Active Geology - The Daily Galaxy
The MOV will conduct when the voltage exceeds 50% of line voltage.
what exactly is a ‘surge’ protector?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
NAR Existing-Home Sales Report Shows 0.8% Increase in May - National Association of REALTORS®
I post the exact comment here.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
One is “what exactly is in a ‘surge protector’ ? ”
Report: Steelers, Dolphins renew talks about a trade for Jonnu Smith - NBC Sports
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
There are two important concepts here.
What are some ways to improve speed in sprinting, running uphill, and long/middle distance running?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Barnstars:
Edit 2024–10.
the problem then depends on "how fast does the fuse operate?".
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
At one ohm, the resistor has a maximum of 1 watt power.
He then describes the function of a fuse.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is 'the assistant's answer'
Dolorum fugit ut molestiae voluptatem minima non.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
First Sentence:
These are simplified answers to the original question, and does not change anything I wrote above.
For this case there are devices called Metal oxide varistors (MOV).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
nine
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
so, what happens?
Because the load is inductive, the current lags the voltage.(by a bit).
Here is a simplified AC power diagram.
These devices are installed between the “hot” and “neutral” and protective ground.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
It seems Mohan does not understand the difference between a comment and an Answer.
eight
[old diagram got deleted by accident]
There are three different concepts here that are getting confused.
but this device (an Inductor) … impedes the rapid changes in the current.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–16 [ OO OLAOYE OYEBODE ]
An AC voltage/ current source, and an ac inductive load.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
a photo is worth a thousand words.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This device then solves the entire problem.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
The other is “what does a “fuse” do?”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Now when you have a certain ac resistance, then a current flows in a loop.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
What does a fuse do?
He then asserts :
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
He then describes Rainy Season and Lightning.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
A circuit breaker is similar, but is resettable.